Step 2: Connect the Contact Sensor with the application

To connect the Contact Sensor with the application, follow the steps below:

1. Log in to the application by entering the registered Email and Password.

2. Tap on the + icon located in the top-right corner of the home screen.

3. If the MHub isn’t already connected, a popup displays to connect the MHub.

4. From the Add new popup, select Device

5. From the Select Device list, tap on the Sensors to expand the section and select Contact Sensor.

6. If the Contact Sensor is not available for connection, insert the pin in the hole at the device’s front to press and hold its reset button for 5 seconds to make it available.

7. Ensure the device’s wireless mesh is turned on to form the connection. If not, the application prompts you to turn it on.

8. A prompt displays once a Contact Sensor is found in the network and is ready to pair. Tap on the Pair button to initiate the pairing.

The application undergoes a few steps to complete the pairing.

9. Once the sensor is successfully paired, tap on the Next button.

10. Enter a name (maximum 26 characters) for the sensor and tap on the Save button.

11. Wait for a few seconds to make the Contact Sensor accessible through the application.