| Safety Instructions: – Do not open the device by yourself or use it if any of its parts are broken. – Operate the device only within indoor environments to keep it sheltered from all weather conditions. – Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them. |
To mount the Contact Sensor, follow the steps below:
1. Insert the tip of a slotted screwdriver into the casing locks at the bottom. Rotate the screwdriver to remove the top cover of the sensor.
2. Insert the 2 x AAA batteries into it, following the correct terminal markings.
3. Clean the surface properly where you want to stick the sensor.
4. Cut the mounting tape and stick it at the back of the Contact Sensor and the magnetic part.
5. Stick the Contact Sensor and magnetic part on the surfaces ensuring that they are aligned parallel to each other.
Note: When sticking the sensor and magnetic part, ensure the distance between both is not more than 10mm.
6. Navigate to the next section to connect your Contact Sensor with the application.