Step 1: Power the Fan Dimmer

Safety Instructions:
– Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done.
– Tighten or loosen the screws when no Live wire is connected.
– Operate the device only within indoor environments to keep it sheltered from all weather conditions.
– Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them.

To power the Fan Dimmer, follow the steps below:

1. Switch off the AC supply from the fuse/circuit breaker.

2. Connect the wires as shown in the figure below:

Wiring diagram of MTronic Fan Dimmer

3. Insert the tip of a slotted screwdriver into the casing locks at the bottom. Rotate the screwdriver to remove the top cover of the Fan Dimmer.

Steps of removing the MTronic Fan Dimmer top cover

4. With the help of a cross-slot screwdriver, fix the back-casing on the wall using the provided mounting screws.

Display of mounting MTronic Fan Dimmer on wall using mounting screws

5. Slide the top cover downwards, into the back-casing, and press at the bottom until it gets locked.

Image displaying the closing of MTronic Fan Dimmer top cover

6. Switch on the AC supply for the Fan Dimmer and wait for at least 30 seconds for a proper operation.

7. Navigate to the next section to connect your Fan Dimmer with the application.