The package includes the following:

1. Housing with pre-assembled lower cover and pre-assembled charging cable x 1
2. Top cover, not mounted x 1
3. Installation and operating manual in German x 1
4. Installation and operating manual in English x 1
5. Datasheet with access data x 1
6. RFID card for authentication x 2
7. Warranty Card x 1
8. Bag with x 1
–  Installation rail x 1
–  Screw 6 x 50 T30 x 5
–  Dowel 8 mm x 5
–  Screw for top cover 3.5 x 12 T15 x 2
–  Strain relief large x 1
–  Strain relief small x 1
–  Screw for strain relief 3.5 x 28 T15 x 2
–  Rubber grommet black small x 1
–  Rubber grommet grey x 2
–  Slotted cable inlet (1 x Inlay 6 mm, 1 x Inlay 2 x 6 mm) x 1
–  CAN bus mating connector x 1

You require the following tools to install the MCharger:
– Screwdriver T15 (for the cover and strain relief screws)
– Screwdriver T30 (for the wall screws)
– Flat-blade screwdriver (for breakthrough openings in the housing)
– Spirit level
– Drilling machine
– Drill bit 8 mm
– Pencil
– Combination pliers (for breakthrough opening at the top of the housing)
– Hammer (for breakthrough openings in the housing)
– Wire stripper

There are two variants available for MCharger:

The available charging cable lengths are 5m and 7m.

The available control methods for MCharger are Wireless, Wired (via Ethernet), and Toggle Switch.