| Safety Instructions: – Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done. – Tighten or loosen the screws when no Live wire is connected. – Operate the device indoors to keep it sheltered from all weather conditions. – Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them. |
| Note: The Smart Curtains Panel can ONLY work with MTronic Smart Curtains. Without MTronic Smart Curtains, the Smart Curtains Panel is not able to perform any functionality. |
To power the Smart Curtains Panel, follow the steps below:
1. Switch off the AC supply from the fuse/circuit breaker.
2. Connect the wires as shown in the figure below:
3. Insert the tip of a slotted screwdriver into the casing locks at the bottom. Rotate the screwdriver to remove the top cover of the Smart Curtains Panel.
4. With the help of a cross-slot screwdriver, fix the back-casing on the wall using mounting screws.
5. Slide the top cover downwards, into the back casing, and press at the bottom until it gets locked.
6. Switch on the AC supply for the Smart Curtains Panel and wait for at least 30 seconds for proper operation.
7. Follow the steps in the next section to connect the Smart Curtains Panel with the application.