| Safety Instructions: – Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done. – Tighten or loosen the screws when no Live wire is connected. – Operate the device only indoors to keep it sheltered from all weather conditions. – Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them. |
To power the Smart Curtains, follow the steps below:
1. Switch off the AC supply from the fuse/circuit breaker.
2. Insert the screwdriver in the track length adjustment key and loosen the screw. Extend the traverse rod as per the required length.
Note: When adjusting the track length of the curtain rod, make sure there is a gap of at least 1 cm from both corners of the windowpane.
3. Once, it’s adjusted, tighten the track length adjustment screw to lock the rod’s length.
4. Press and hold the carrier adjustment button and drag the right and left carriers to the desired adjustment. Once done, release the carrier adjustment button.
5. Attach the brackets to the rod.
Note: Ensure the interval between brackets is less than or equal to 60cm.
6. Fix the rod on the wall by screwing the mounting brackets.
7. Insert the shaft in the opening towards the main drive unit of the curtain rod and rotate it 90 degrees to fix the motor.
8. Connect the motor to the relay as per the following wiring diagram:
9. Once done, hang the curtain fabric.
10. It is ready for connection as soon as it’s powered on.
11. Navigate to the next section to connect the Smart Curtains with the application.