| Safety Instructions: – Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done. – Tighten or loosen the screws when no Live wire is connected. – Since the installation requires working with high voltages, it MUST be installed and uninstalled by an expert electrician. – Label the wires when removing the existing thermostat (if any) to make the connections easier. – Operate the device only within indoor environments to keep it sheltered from all weather conditions. – Do not allow children to play with the device or its packaging, as its plastic film and small components may pose a choking hazard to them. |
To power your HVAC Touch Panel, follow the steps below:
1. Switch off the AC supply from the fuse/circuit breaker.
2. Connect the Live Wire in the terminal marked as L and the Neutral Wire in the terminal marked as N.
3. Insert the tip of a slotted screwdriver into the casing locks at the bottom. Rotate the screwdriver to remove the top cover of the panel.
4. With the help of a cross-slot screwdriver, fix the back-casing on the wall using the provided mounting screws.
5. Slide the top cover into the plastic casing, and press at the bottom until it gets locked.
6. Switch on the AC supply for the panel and wait for at least 30 seconds for proper operation.