Step 1: Power the Roller Blind

Safety Instructions:
– Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done.
– Tighten or loosen the screws when no Live wire is connected.
– Operate the device only within indoor environments to keep it sheltered from all weather conditions.
– Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them.

To power the Roller Blind, follow the steps below:

1. Switch off the AC supply from the fuse/circuit breaker.

2. Screw the mounting brackets in the corners of the windowpane using the mounting screws.

3. Connect the wires as shown in the figure below.

Wiring diagram of MTronic Roller Blind

4. Fix the Roller Blind in the window carefully by mounting them on the brackets.

5. Lock the Roller Blind into mounting brackets using locking pins.

6. Switch on the AC supply for the Roller Blind and wait for at least 30 seconds for proper operation.

7. Navigate to the next section to connect the Roller Blind with the application.