| Safety Instructions: – Ensure there are appropriate fuse/circuit breakers installed for the space and turn them off before installation. Turn them on only after the installation is done. – Tighten or loosen the screws when no Live wire is connected. – Operate the device only within indoor environments to keep it sheltered from all weather conditions. – Do not allow children to play with the device or its packaging as its plastic film and small components may pose a choking hazard to them. |
To power your Touch Panel, follow the steps below:
1. Switch off the AC supply from the fuse/circuit breaker.
2. Based on your Touch Panel’s type, connect the wires as shown in the figures below.
3. Insert the tip of a slotted screwdriver into the casing locks at the bottom. Rotate the screwdriver to remove the top cover of the Touch Panel.
4. With the help of a cross-slot screwdriver, fix the back-casing on the wall using the provided mounting screws.
5. Slide the top cover downwards, into the plastic casing, and press at the bottom until it gets locked.
6. Switch on the AC supply for the Touch Panel and wait for at least 30 seconds for proper operation.
7. Follow the steps in the next section to connect your Touch Panel with the application.